Heating/cooling head with two sections of 8" dia coated duct.
			Heating/cooling head shown with controller.
	OVERVIEW Fab-Tech's PermaBond process provides gasket free joints for 4" to 14" diameter coated PSP® duct.  Basically the process applies high heat to an aligned and squeezed duct joint.  This focused heat causes the coating of the mating duct flanges to soften and eventually meld into a uniform seal.  Once cooled, the joint is strengthened with a proprietary PSP-EZ clamp.  PermaBonded duct is sealed to a class suitable for helium leak testing. PROCESS STEPS 1. Fasten heating/cooling head to a aligned duct joint. 2. Apply axial load to (squeeze) the joint together. 3. Press "Start" on the controller. 4. Soak the joint for a preset interval at elevated temperature. 5. Soften coating of the mating duct flanges to point of flow. 6. Cool the joint under continued axial load. 7. Print joint thermal cycle. 8. Remove heating/cooling head and install EZ clamp. CONTROLLER (DRAGON) - The Controller is the brain and muscle for the heat bonding process, providing computer control   for heating and cooling functions. - Furnished with a touch screen interface to display process status, a printout of each joint thermal   cycle is provided. - Monitors itself and the bonding process for errors. - Available as a dual head configuration to allow two joints to be bonded simultaneously. - 100% duty cycle. - Uses standard 208V three phase power 30 amps per leg, through a NEMA (L21-30P outlet). - The time required to bond a joint varies with size, but most require less than 20 minutes for a   complete cycle. HEATING/COOLING HEADS - Heads are available for sizes 4"-14" inclusive as interchangeable units. - Heads also incorporate heat shrouds for a surface temperature of ~160°F during bonding. - For the cooling phase, the duct surfaces are cooled to 150°F before the heating/cooling head   is removed. - Does not produce smoke or odors under normal operation. - Production units include 25' cables and hoses for convenient reach of heating/cooling heads. PSP-EZ™CLAMP - Bonded joints support PSP-EZ™ clamps and would posses the same resistance to bending    loads up to 250lbs. - Clamped joints will maintain structural integrity and will not separate in the event of fire. - Fab-Tech's PSP-EZ™ clamp system as well as the PermaBond process is FM Global approved.
			Controller graph showing heating/cooling data for a bonded joint.
			Clamped heating/cooling head.
			Rear view of controller.